materials: steel hook size - 1.30mm
any kinds of cotton thread. (i use monaco thread)
velcro tape
tapestry needle.
row 1: ch 12, hdc in 3rd ch from hook,
1 hdc in ea of next 8 sts,
3 hdc in last ch, Working on opposite side.
1 hdc in ea of next 8 sts, 3 hdc in last st.
(DO NOT JOIN)
ROW 2 TO 38: (working n continual round)
1 hdc in each st acrcoss. (22hdc) FASTEN OFF.
FLAP:
ROW 1: Attach thread with a sl st at the 1st st at the top right side edge
(the back of the case is still facing you),
work 1 hdc in each of next 12 sts, ch 1 turn.
row 2 to 7: 1 hdc in each of next 12 sts, ch 1 turn. fasten off.
CLOSURE:
I used Velcro as closures for this hook case:
Sew approximately a 1 inch square of Velcro near each end edge and at the center on the wrong side of
the Flap and to the outside face of the hook case to correspond in placement.
